
ESP32-CAM Pinout, Code Upload and First Project
ESP32-CAM complete guide. Source: DIY Engineers (YouTube) The ESP32-CAM in 30 Seconds The ESP32-CAM is AI-Thinker’s 27 x 40.5 mm board: an ESP32 chip, an OV2640 2 MP camera, 4 MB PSRAM, 4 MB flash, a microSD slot and a flash LED. It breaks out 16 pins, but with the camera running very few are truly free. Add the SD card and you are left with GPIO12 and GPIO13, and only if the card runs in 1-bit mode. There is no USB port. You upload with an ESP32-CAM-MB adapter, a USB-serial adapter or an Arduino Uno, and GPIO0 must be pulled to GND at upload time. Power it from 5 V. A 3.3 V supply or a thin USB cable is the number one cause of “Brownout detector was triggered”. In the Arduino IDE the board is AI Thinker ESP32-CAM. In the current CameraWebServer example the camera model is picked in board_config.h, not in the .ino file. Camera init failed with error 0x105 means the camera was not detected: check the ribbon cable first. A Wi-Fi camera for about the price of a coffee. That is why the ESP32-CAM shows up in baby monitors, doorbells, bird box cams and timelapse rigs. ...